Hi Søren,
good job!! Due to white wing and red fuselage I guess you made it from the 2021 glider version?
If so, could you please explain the way you built the wing?
Did you cut off some foam at the trailing edge to make the edge thicker and stronger (similar to the older version) before fixing the ailerons?
Thank you for sharing and explaining!
Cheers
Stephan
Hi Stephan
It is one of the old versions with the thick trailing edge, and the same with this yellow one.
I just made this one today the same way
In the wing I first made a cut in the leading edge that will be inside the fuselage, and together with a hole in in the fuselage this is the ballast room for up to 100 gram extra inside ballast.
And there is no extra wing spar, wing just glued in the fuselage with hot glue.
And the outher ailerons are pulled by a small piece blenderm tape,
3 mm balsa ailerons.
Cheers
Soren